Diagnostic Test
- VERIFY DTC IS ACTIVE NOTE:
This DTC must be active for the results of this test to be valid.
- Perform any Service Bulletins that may apply.
- Turn the ignition on.
- With the scan tool, read ABS DTCs and record on the repair order.
- Cycle the ignition switch from off to on.
- With the scan tool, read the DTCs.
Is the DTC active?
Yes
- Go To 2
No
- Perform the ABS-INTERMITTENT CONDITION TEST. Refer to ABS INTERMITTENT CONDITION .
- CHECK IF TRANSMISSION CONTROL MODULE (TCM) DTCS ARE PRESENT
- With the scan tool, read TCM DTCs.
Are there any TCM DTCs present?
Yes
- Perform the appropriate diagnostic procedures. Refer to 948TE/9HP48 AUTOMATIC TRANSMISSION - DIAGNOSTIC CODE INDEX .
No
- Go To 3
- With the scan tool, read TCM DTCs.
- CHECK OTHER MODULES FOR CAN BUS DTCS
- With the scan tool, read the DTCs.
Are there any CAN BUS DTCs present?
Yes
- Using the schematics as a guide, check the Transmission Control Module (TCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Transmission Control Module (TCM) in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL .
No
- Using the schematics as a guide, check the Anti-lock Brake System (ABS) Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM (ABS), REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
- With the scan tool, read the DTCs.