LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Renegade Trailhawk >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Cluster (Service Information) >> Pod, Switch >> Removal And Installation >> Removal

Removal And Installation: Removal

GC0163636Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the radio from the instrument panel to gain access to the switch pod retaining tabs (1a). Refer to RADIO, REMOVAL AND INSTALLATION .
  3. Using a trim stick C-4755 or equivalent, remove the switch pod (1b) from the instrument panel while compressing the retaining tabs (1a).
  4. Disconnect the switch pod wire harness connector (2) from the switch pod (1b).
  5. Remove the switch pod (1b) from the vehicle.
scientia non olet · About LEMON Manuals