Sealer Application

WARNING: This page is about a different variant/trim than selected.

Apply 1 mm (0.040 in.) diameter or less of MOPAR® Gasket Maker material to one gasket surface. Be certain the material surrounds each mounting hole. Excess material can easily be wiped off. Tighten the components in place while the sealant is still wet to the touch. Use a locating dowel during assembly to prevent smearing material off the location.

Apply MOPAR® RTV or ATF-RTV gasket material in a continuous bead approximately 3 mm (0.120 in.) in diameter. For corner sealing and "T-Joint" locations and waffle pad area, a 0.635 mm (0.025 in.) drop is placed in the center of the gasket contact area. Remove uncured sealant with a shop towel. Tighten the components in place while the sealant is still wet to the touch. Use a locating dowel during assembly to prevent smearing material off the location.