Possible Causes
WARNING: This page is about a different variant/trim than selected.
| Possible Causes |
|---|
| INTERMITTENT WIRING CONNECTION/CONNECTOR ISSUE |
| TPS 1 SIGNAL CIRCUIT AND TPS 2 SIGNAL CIRCUIT SHORTED TOGETHER |
| TPS 1 SIGNAL CIRCUIT SHORTED TO THE 5-VOLT SUPPLY CIRCUIT |
| TPS 2 SIGNAL CIRCUIT SHORTED TO THE 5-VOLT SUPPLY CIRCUIT |
| HIGH RESISTANCE IN THE TPS 1 OR TPS 2 SIGNAL CIRCUIT |
| HIGH RESISTANCE IN THE TPS RETURN CIRCUIT |
| HIGH RESISTANCE IN THE 5-VOLT SUPPLY CIRCUIT |
| THROTTLE POSITION SENSOR/THROTTLE BODY |
| POWERTRAIN CONTROL MODULE (PCM) |
Always perform the PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE before proceeding. Refer to PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .