Description And Operation: Description

The dual pane sunroof system consists of a front sliding glass panel and rear stationary glass panel which allows additional sun light and/or ventilation into the interior of the vehicle. The system also includes a power sunshade which can be closed when additional sun light is not desired.

The dual pane sunroof system allows the sunroof front glass to be opened, closed or placed in the vent position electrically by actuating switches in the overhead console. The sunroof system receives battery voltage through a fuse in the Power Distribution Center (PDC) and an ignition voltage to determine vehicle ignition state. The sunroof will only operate when the ignition is set to ON/RUN. The sunroof system does not communicate through Controller Area Network (CAN) Bus. Therefore, the power sunroof system does not generate Diagnostic Trouble Codes (DTCs).

The dual pane sunroof system features an express operation (press & release switch) convenience feature that will automatically open or close the sunroof or sunshade. The glass features two programmed stop positions; comfort stop position and full open position. The comfort stop position is approximately 40 mm (1.6 in.) forward of the full open position and has been optimized to minimize wind noise in the interior when the vehicle is driven with sunroof open and all side windows closed. In addition, the power sunroof system also features an obstacle detection feature which automatically reverses the sunroof or sunshade when it encounters an obstacle within the roof opening during express close operation.

The sunroof glass can be cycled to the following positions:

• Vent Position  - The sunroof glass panel tilts upward 25 mm (1 in.) at the rear for the Vent position.
• Comfort Stop Position  - The sunroof glass panel slides open approximately 475 mm (18.7 in.) from the closed position.
• Full Open Position  - The sunroof glass panel slides open approximately 515 mm (20.3 in.) from the closed position.
• Closed Position  - The sunroof glass panel seals flush with the roof in the closed position to eliminate wind noise.

There are two electric motors located on the rear of the dual pane sunroof assembly that operate the sliding glass panel and sunshade.

The dual pane sunroof glass panels interface with the body roof opening flange with rubber seals to prevent wind noise and minimize water intrusion when the sunroof is closed. The sunroof system features a water management system that collects any water that leaks passed the sunroof seals and drains it safely outside the vehicle through drain hoses connected at all four corners of the sunroof frame.

The sunroof system features a wind deflector that automatically deploys when the sunroof is in the open position to help minimize wind noise.

The main components of the dual pane sunroof system are:

• Front Glass Panel
• Rear Glass Panel
• Frame and Mechanism
• Motor Assemblies
• Power Sunshade
• Overhead Switches
• Wind Deflector
• Drain Hoses