LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee Trailhawk >> Repair and Diagnosis >> Electrical >> Gauges >> Body - Interior & Exterior >> Seats, Front >> Cover, Seat Back, Power >> Removal

Cover, Seat Back, Power: Removal

WARNING:

Disable the airbag system before attempting any front seat diagnosis or service. Disconnect and isolate the negative battery (ground) cable and wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Before proceeding with the following repair procedure, review all warnings and cautions. Refer to SEATS, FRONT, WARNING .
  2. Remove the seat from the vehicle. Refer to SEAT, REAR, REMOVAL .
  3. Remove the headrest sleeves. Refer to SLEEVE, HEADREST, REAR, REMOVAL .
    GC0176900Courtesy of CHRYSLER GROUP, LLC
  4. Release the lower J-hook strip (2).
  5. Open the side zippers (1) on each side of the seat back cover.
    GC0176962Courtesy of CHRYSLER GROUP, LLC
  6. Lift the seat back trim slightly and remove the push fasteners (1) on each side.
    GC0176983Courtesy of CHRYSLER GROUP, LLC
  7. Lift the seat back trim and release the J-hook retainers (2).
  8. Disconnect the wire harness connector (1) for the seat heating pad, if equipped.
  9. Remove the seat air bag from the seat back frame, following all warnings and cautions. Refer to AIR BAG, SEAT, REMOVAL .
    GC0176981Courtesy of CHRYSLER GROUP, LLC
  10. Using a trim tool, unclip the vent pad (3) from the vent motor (1).
  11. Remove the seat back foam and seat back cover as an assembly, from the seat back frame.
    GC0176968Courtesy of CHRYSLER GROUP, LLC
  12. Pull the seat back cover (2) away from the seat foam (1) cutting the hog rings and remove.
scientia non olet · About LEMON Manuals