Panel, Door Trim: Removal

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
Using (special tool #C-4755, Trim Stick) or equivalent, remove and disconnect the window switch (1) from the door.
Using a trim stick or equivalent, remove the liner (4) from the door trim pull handle.
Remove the fastener (3) securing the door trim panel to the carrier plate.

Courtesy of CHRYSLER GROUP, LLC
Using a trim stick or equivalent, pull out on the interior door handle and remove the bezel (2) located in the cavity.
Remove the fastener (1) securing the door trim panel to the carrier plate.

Courtesy of CHRYSLER GROUP, LLC
Using a trim stick or equivalent, pry the door trim panel away, starting along the lower edge and working around the perimeter to disengage the retaining clips (3).
Lift the door trim panel up and out.Position the door trim panel slightly away, do not remove.

Courtesy of CHRYSLER GROUP, LLC
Disconnect the wire harness connector (3).
Disconnect the interior handle cables (2) and remove the door trim panel.

Courtesy of CHRYSLER GROUP, LLC
Remove the inner belt molding (1).

Courtesy of CHRYSLER GROUP, LLC
Using a (special tool #C-4829A, Remover, Trim) or equivalent, remove the push pin fasteners (1) and remove the upper trim (2).