Slider Rear Seat-60%
- Remove the 60% slider rear seat. Refer to SEAT, REAR, REMOVAL .
- Release the J-clips (1).
- Release the hook and loop fasteners (1).
- If equipped with seat cushion heat, disconnect the wire harness connector and unclip the wire harness from the seat frame.
- Release clip strips (1) at the front and both sides of the seat cushion.
- Remove the cushion cover and the cushion foam as an assembly from the seat frame.
- Pull the cushion cover (1) away from the cushion foam, releasing the hook and loop fasteners.
- Cut all the hog rings (2) and remove the cushion cover.