Glass, Door: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the door trim panel. Refer to PANEL, DOOR TRIM, REMOVAL .
- Using a trim stick or equivalent, pry upward to remove the inner door belt weatherstrip (2) to allow the door glass (1) clearance.
- Disconnect the window motor (2) wire harness connector.
- Remove the window motor fasteners (1).
- Remove the window motor (2) from the carrier plate.
- Open the access plugs (2) to expose the glass fasteners (3).
- Lower the glass by hand until the glass fasteners (3) line up in the access holes.
- Remove the glass fasteners (3).
- Lift up on the rear portion of the glass (2) to tilt.
- Remove the glass (2) from the door (1).