LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2021 >> Cherokee Latitude Plus, FWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Body - Interior & Exterior >> Seats, Rear >> Cover, Rear Seat Back, 60% >> Removal >> Slider Rear Seat

Slider Rear Seat

  1. Remove the 60% slider rear seat from the vehicle. Refer to SEAT, REAR, REMOVAL .
  2. Remove the armrest. Refer to ARMREST, REAR, REMOVAL .
    GC0176965Courtesy of CHRYSLER GROUP, LLC
  3. Remove the center seat belt fastener (1).
    GC0176922Courtesy of CHRYSLER GROUP, LLC
  4. Using a trim tool, release the clips and remove the right side shield (1).
    GC0176977Courtesy of CHRYSLER GROUP, LLC
  5. Remove the fastener (2), then lift the left side shield (1) and remove.
    GC0176914Courtesy of CHRYSLER GROUP, LLC
  6. Open the lower J-strip (2) and unzip (3) both sides of the seat back trim.
  7. Lift the seat back trim and unclip trim covers (1).
    GC0177007Courtesy of CHRYSLER GROUP, LLC
  8. Lift the seat back trim and remove the push fasteners (1).
    GC0176933Courtesy of CHRYSLER GROUP, LLC
  9. Remove the fasteners (1) to loosen the armrest support.
    GC0176982Courtesy of CHRYSLER GROUP, LLC
  10. If equipped with seat back heat, unclip the wire harness (2) from the seat frame.
    GC0176986Courtesy of CHRYSLER GROUP, LLC
  11. If equipped with seat back heat, unclip (2) and disconnect the wire harness connector (3).
    GC0176961Courtesy of CHRYSLER GROUP, LLC
  12. Lift the handle (1), remove the fastener then the fold flat handle bezel (2).
    GC0177016Courtesy of CHRYSLER GROUP, LLC
  13. Carefully loosen the small J-strips (1) around the handle opening.
    GC0177074Courtesy of CHRYSLER GROUP, LLC
  14. Remove the fasteners (1), then the seat belt trim cover (2).
    GC0176960Courtesy of CHRYSLER GROUP, LLC
  15. Using a trim tool (1), carefully remove the outboard and center headrest sleeves (2).
    GC0176890Courtesy of CHRYSLER GROUP, LLC
  16. Remove the inner armrest trim cover (1).
  17. Remove the seat back cover and the seat back foam as an assembly from the seat back frame.
    GC0176958Courtesy of CHRYSLER GROUP, LLC
  18. If necessary to remove the inner side shields (2), remove the fasteners (1) and the inner side shield.
    GC0176911Courtesy of CHRYSLER GROUP, LLC
  19. With the seat back cover on a bench, remove the push fasteners (1 and 3), the J-strips (2), then remove the armrest support (4).
    GC0177012Courtesy of CHRYSLER GROUP, LLC
  20. Pull the seat back cover (2) away from the seat back foam, releasing the hook and loop fasteners.
  21. Cut all the hog rings and remove the rear seat back cover.
scientia non olet · About LEMON Manuals