Switch, Headlamp: Installation
WARNING:
To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.
- Align the headlight switch to the mounting location in the instrument panel steering column opening cover.
- Using hand pressure, push the switch through in order to seat the switch to the housing. Make sure both pawl retainers (1) have cleared the opening and are retaining the switch to the cover.
- Connect the wire harness connector to the headlight switch harness receptacle (2).
- Install the lower steering column cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.