Stationary Glass: Windshield: Removal
- Before proceeding with the following repair procedure, review all warnings and cautions.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the rear view mirror. Refer to MIRROR, REARVIEW, REMOVAL .
- Remove the exterior cowl panel. Refer to COVER, COWL PANEL, REMOVAL .CAUTION:
Be careful not to damage painted surfaces when removing moldings or cutting urethane around the windshield.
- Remove the molding from the top of the windshield.
- Using an assistant and a wire-type windshield cut-out tool (1, 3 and 4), cut and separate the urethane adhesive (2) securing the windshield to the windshield fence.
- Using appropriate tools, carefully remove the windshield (1) from the vehicle.