Glass, Door: Removal
- Remove the rear door trim panel. Refer to PANEL, REAR DOOR TRIM, REMOVAL .
- Remove the C-pillar applique. Refer to APPLIQUE, REMOVAL .
- Disconnect the window motor wiring harness connector (3).
- Remove the fasteners (2) from the window motor (1).
- Remove the window motor (1) from the carrier plate.
- Open the access plugs (3) on the carrier plate.
- Position the glass by hand until the glass fasteners line up in the access hole (2).
- Remove the glass fasteners.
- Remove the glass (1) from the vehicle.