Diagnostic Test

This transmission is equipped with a solenoid for the Torque Converter Clutch (TCC) that is a Variable Force Solenoid (VFS) with close tolerance Pressure/Inductance (PI) curve. If replacing the PCM, it is necessary to transfer the PI data from the old PCM to the new PCM using the scan tool. If the PCM being replaced is non-responsive, the PI data can be retrieved from a 2-D bar code on the exterior of the transmission case. This is done with the scan tool using the "Program Torque Converter Solenoid PI Curve" routine.

Early build transmissions will have the 2-D barcode label on the right side of the transmission case. Late build transmissions will have the label attached to a machined pad at the top of the case, near the rear of the transmission. The data must be entered into the scan tool in order to upload the information to the PCM. In the event that the exterior BAR code is missing, or it is suspected that the valve body or TCC solenoid has been replaced without uploading the correct PI data into an existing PCM, the transmission oil pan must be removed to retrieve the information from the 2-D bar code on the body of the TCC solenoid.

This transmission is equipped with a solenoid for the Torque Converter Clutch (TCC) that is a Variable Force Solenoid (VFS) with close tolerance Pressure/Inductance (PI) curve. If replacing the PCM, it is necessary to transfer the PI data from the old PCM to the new PCM using the scan tool. If the PCM being replaced is non-responsive, the PI data can be retrieved from a 2-D bar code on the right side exterior of the transmission case. The data must be entered into the scan tool in order to upload the information to the PCM. In the event that the exterior BAR code is missing, or it is suspected that the valve body or TCC solenoid has been replaced without uploading the correct PI data into an existing PCM, the transmission oil pan must be removed to retrieve the information from the 2-D bar code on the body of the TCC solenoid.