Diagnostic Test

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM TRANSMISSION CONTROL MODULE (TCM) PROGRAMMING PROCEDURE

With the scan tool, attempt to program the TCM with the latest calibrations in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), MODULE PROGRAMMING .
Were you able to program the TCM successfully?

Yes
- Test complete.
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
No
- Using the schematics as a guide, check the TCM connector and all related in-line connector terminals for corrosion, damage, or pushed out terminals. Pay particular attention to the power and ground circuits. If no problems are found, replace and program the TCM in accordance with the Service Information. Refer to MODULE, TRANSMISSION CONTROL (TCM), REMOVAL AND INSTALLATION .
- Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .