Diagnostic Test

WARNING: This page is about a different car, the 2019 RAM 3500 HD and 2019 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

READ AND RECORD DTCS AND ENVIRONMENTAL DATA - ERASE DTCS AND CHECK FOR DTC TO RETURN

With the scan tool, read DTCs in all Electronic Control Units (ECUs) and record on the repair order.
With the scan tool, run a vehicle Scan Report, or record the Environmental Data related to the DTCs.
NOTE: A front door must remain open whenever checking or erasing Radio DTCs.
With the scan tool, record and erase the Radio DTCs.
Cycle the ignition switch from on to off, wait five seconds and then back to on.
Turn the Radio on and set the volume to 25.
With the scan tool, read the active Radio DTCs.

NOTE:

A front door must remain open whenever checking or erasing Radio DTCs.

Did the DTC return?

Yes

Replace the Radio in accordance with the Service Information. Refer to RADIO, REMOVAL AND INSTALLATION .
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .

Test complete.
Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .