Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read LBSS DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- Cycle the ignition from on to off, wait five seconds and then back to on.
- With the scan tool, read LBSS DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- CHECK SENSOR AND INPUTS TO THE LBSS
- With the scan tool, check all sensor and input data in the LBSS module.
Are there any sensor and input data displaying Signal Not Available (SNA)?
Yes
- Repair the faulty sensor or input data.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete.
- With the scan tool, check all sensor and input data in the LBSS module.