When Monitored
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
This diagnostic runs continuously when the following conditions are met:
- Comparison to Temperature Model:
- Ignition On.
- No oil temperature sensor circuit high or low DTCs set.
- No oil temperature jump detection DTCs set.
- The engine speed is greater than a calibrated value or the input speed is greater than a calibrated value.
- The output speed is greater than a calibrated value.
- Line Pressure Control Solenoid power supply is switched on.
- No supply voltage of Line Pressure Control Solenoid monitoring DTCs set.
- No Line Pressure Control Solenoid circuit monitoring DTCs set.
- Calibrated time has expired after engine start.
- Low Temperature Detection:
- Ignition On.
- No oil temperature sensor circuit high or low DTCs set.
- No oil temperature jump detection monitoring DTCs set.
- The engine speed is greater than a calibrated value or the input speed is greater than a calibrated value.
- The output speed is greater than a calibrated value.
- Stuck in Low Temperature Detection:
- Ignition On.
- No oil temperature sensor circuit high or low DTCs set.
- No oil temperature jump detection monitoring DTCs set.
- The engine speed is greater than a calibrated value or the input speed is greater than a calibrated value.
- The output speed is greater than a calibrated value.
- Transmission oil temperature is less than a calibrated value.