Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC NOTE:
Before proceeding with this diagnostic procedure, remove any ice, snow, mud, dirt, or other obstructions from the front/rear fascia/bumper. Also remove any ice, snow, dirt, mud, or other obstructions from the underside of the Fascia/Bumper surrounding the sensors.
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- Cycle the ignition key on 3 times.
- With the scan tool, read PAM DTCs.
Is the DTC active?
Yes
- Go To 2
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- PARK ASSIST SENSOR
- Verify that none of the possible causes mentioned above are present. Repair as necessary.
If none of the possible causes mentioned above are present, view repair.
Repair
- Replace the Park Assist Sensor in accordance with the Service Information. Refer to SENSOR, PARK ASSIST, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Verify that none of the possible causes mentioned above are present. Repair as necessary.