When Monitored

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

This diagnostic runs one time during an ignition cycle when the following conditions are met:

Ignition on.
System voltage above 10.38 volts.
Stop/Start enabled.
Condition one:
- The Starter Relay is commanded closed (on).
- Ignition Run 2 Relay commanded open (off).
Condition two:
- The Starter Relay is commanded open (off).
- Ignition Run 2 Relay commanded open (off).