Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC

With the scan tool, read Body Control Module (BCM) DTCs and record on the repair order.
Record the Environmental Data.
With the scan tool, erase DTCs.
Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
With the scan tool, read BCM DTCs.
Did the DTC return?

Yes
- Check the Fuel Mode Switch for anything that may cause a sticking condition. If no problems are found, replace the Fuel Mode Switch in accordance with the Service Information.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Perform the TESTING FOR INTERMITTENT CONDITIONS procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .