LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1373 (Body Control Module (BCM) - DTCS B1046-64 To B1166-71) >> DTC Troubleshooting >> B1104-24-Physical Key In Start Position-Signal Stuck High >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE IGNITION SWITCH 

  1. Attempt to turn the Ignition Key from on to off.

    Does the Ignition Key turn form on to off?

    Yes 

    No 

    • Inspect the Ignition Key and the Ignition Switch for any foreign objects that may cause a sticking condition. If no problems are found, replace Ignition Key and Ignition Switch in accordance with the Service Information. Refer to SWITCH, IGNITION, REMOVAL AND INSTALLATION .
    • Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .