Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read Amplifier DTCs and record on the repair order.
- With the scan tool, erase DTCs.
- Using the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read Amplifier DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
- LEFT SUBWOOFER ELECTRICAL CONNECTION CHECK
- Turn the ignition off.
- Disconnect the Left Subwoofer and Amplifier harness connectors.
- Check for the presence of loose or damaged connections at the Left Subwoofer and Amplifier harness connectors.
Were there signs of any of the connections being loose or damaged?
Yes
- Restore the correct connections.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3
- CHECK THE LEFT SUBWOOFER FOR A SHORT TO GROUND
- Check for continuity between ground and the Left Subwoofer Signal circuit at the Left Subwoofer harness connector.
Was a short to ground detected?
Yes
- Repair the Left Subwoofer Signal circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 4
- Check for continuity between ground and the Left Subwoofer Signal circuit at the Left Subwoofer harness connector.
- CHECK THE LEFT SUBWOOFER SIGNAL CIRCUIT FOR AN OPEN/HIGH RESISTANCE
- Measure the resistance of the Left Subwoofer Signal circuit between the Left Subwoofer harness connector and the Amplifier harness connector.
Is the resistance below 3.0 Ohms?
Yes
- Go To 5
No
- Repair the Left Subwoofer Signal circuit for an open or high resistance.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Measure the resistance of the Left Subwoofer Signal circuit between the Left Subwoofer harness connector and the Amplifier harness connector.
- CHECK FOR A SHORT BETWEEN THE LEFT SUBWOOFER CIRCUITS
- Check for continuity between circuits at the Left Subwoofer harness connector.
Was there a presence of a short between circuits in the Left Subwoofer wiring?
Yes
- Repair the short between circuits in the Left Subwoofer wiring.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 6
- Check for continuity between circuits at the Left Subwoofer harness connector.
- CHECK THE LEFT SUBWOOFER FOR A SHORT TO VOLTAGE
- Turn the ignition on.
- Measure the voltage on the Left Subwoofer Signal circuit at the Left Subwoofer harness connector.
Is there any voltage present?
Yes
- Repair the Left Subwoofer Signal circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 7
- CHECK THE LEFT SUBWOOFER OPERATION
- Check that the Left Subwoofer is working correctly.
Is the Left Subwoofer working correctly?
Yes
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Left Subwoofer in accordance with the Service Information. Refer to SPEAKER, REMOVAL AND INSTALLATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- Check that the Left Subwoofer is working correctly.