Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read Amplifier DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read Amplifier DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
LEFT SUBWOOFER ELECTRICAL CONNECTION CHECK
1. Turn the ignition off.
2. Disconnect the Left Subwoofer and Amplifier harness connectors.
3. Check for the presence of loose or damaged connections at the Left Subwoofer and Amplifier harness connectors.
  Were there signs of any of the connections being loose or damaged?
  
  Yes
  - Restore the correct connections.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Go To 3
CHECK THE LEFT SUBWOOFER SIGNAL CIRCUIT FOR AN OPEN/HIGH RESISTANCE
1. Measure the resistance of the Left Subwoofer Signal circuit between the Left Subwoofer harness connector and the Amplifier harness connector.
  Is the resistance below 3.0 Ohms?
  
  Yes
  - Go To 4
  No
  - Repair the Left Subwoofer Signal circuit for an open or high resistance.
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
CHECK THE LEFT SUBWOOFER OPERATION
1. Check that the Left Subwoofer is working correctly.
  Is the Left Subwoofer working correctly?
  
  Yes
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
  No
  - Replace the Left Subwoofer in accordance with the Service Information. Refer to SPEAKER, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .