Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
CHECK FOR AN ACTIVE DTC
- Turn the ignition on.
- With the scan tool, erase DTCs in the BCM.
- Cycle the ignition on and off several times, leaving the ignition on for at least 20 seconds during each ignition cycle.
- Turn the ignition on.
- With the scan tool, read DTCs in the BCM.
Is the DTC active or pending?
Yes
- Refer to DIAGNOSTIC CODE INDEX and perform the appropriate diagnostic procedure.
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .