Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read PAM DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read PAM DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE PAM DATA VALUES WITH THE SCAN TOOL
1. With the scan tool, check the data in the PAM for incorrect/inaccurate inputs or (SNA) Signal Not Available data values.
  Is there any incorrect/inaccurate inputs or (SNA) values?
  
  Yes
  - Trace and repair the faulty input or (SNA) messages from the BCM.
  No
  - Test complete.