Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. Verify the Park Assist Sensor is connected before proceeding with this diagnostic procedure.
  NOTE:
  A disconnected sensor will set this DTC.
  
  With the scan tool, read DTCs and record on the repair order.
2. With the scan tool, erase DTCs.
3. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
4. With the scan tool, read DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
PARK ASSIST SENSOR
1. Verify that none of the possible causes mentioned above are present. Repair as necessary.
  If possible none of the causes mentioned above are present, view repair.
  
  Repair
  - Replace the Park Assist Sensor in accordance with the Service Information. Refer to SENSOR, PARK ASSIST, REMOVAL AND INSTALLATION .
  - Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .