Electric Park Brake (EPB): Notes
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Using the (EPB), do not block the rear wheels.
| STEP | WHAT TO DO | THE RESULTS OF THE CHECKS | ||
|---|---|---|---|---|
| 1 | CHECK WITH DIAGNOSTIC TOOL | EVERYTHING OK | PROBLEMS ENCOUNTERED | INTERVENTION |
Connect the diagnosis tool and check on the ABS module unit running errors:
in parameters:
|
Continue to step 2 | 1. Failure to communicate with the ABS module | 1. Restore the correct feeding of the ABS module | |
| 2. The presence of errors in ABS module unit | 2. Continue as directed by the diagnosis tool | |||
| 2 | CHECK WITH DIAGNOSTIC TOOL | EVERYTHING OK | PROBLEMS ENCOUNTERED | INTERVENTION |
|---|---|---|---|---|
| With diagnostic tool connected, run under actuators diagnosis of rear brake calipers | Continue to step 4 | Actuators do not turn on | Continue to step 3 |
| 3 | CHECK WITH DIAGNOSTIC TOOL | EVERYTHING OK | PROBLEMS ENCOUNTERED | INTERVENTION |
|---|---|---|---|---|
| Check the continuity/isolation of electrical connections between ABS module and actuators rear calipers | Continue to step 4 | 1. Faulty electrical connections | 1. Restore electrical connections | |
| 2. Electrical connections are correct: actuator anomaly | 2. Replace rear brake calipers actuators. Refer to ACTUATOR, ELECTRIC PARK BRAKE, REMOVAL . |
| 4 | CHECK WITH DIAGNOSTIC TOOL | EVERYTHING OK | PROBLEMS ENCOUNTERED | INTERVENTION |
|---|---|---|---|---|
| Verify the correct operation of the static and dynamic brake | End of diagnosis | Problem persists | Replace ABS controller. Refer to INTEGRATED CONTROL UNIT (ICU), REMOVAL AND INSTALLATION . |