LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1353 (Vehicle Theft Security (Service Information)) >> Module, Ultrasonic And Anti-Tilt >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0169396Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the overhead console with lamp unit (4) from the headliner. Refer to CONSOLE, OVERHEAD, FRONT, REMOVAL .
  3. Disconnect the overhead console wire harness connector (2) from the Ultrasonic and Anti-tilt Module (UAM) (1).
  4. Remove the fasteners (3) that secure the mounting tabs of the UAM to the overhead console.
  5. Disengage and remove the UAM from the overhead console.
scientia non olet · About LEMON Manuals