LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1351 (Power Windows (Service Information)) >> Switch, Power Window >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the driver door gang switch to the door panel and connect the wire harness connectors.
  2. Install the driver door gang switch into the door panel. Make sure the retainers are fully engaged with the door panel.
  3. Install the hand well to the door panel then install and securely tighten the screw.
  4. Insert the pad.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals