Filler Neck: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Be certain that the two O-ring seals on the base of the filler neck are properly positioned and in good condition.
- Position the filler neck (1b), retainer and filler cap into the left front corner of the engine compartment as a unit.
- Align the base of the filler neck (2a) with the filler neck fitting on the top of the reservoir.
- Use a back and forth twisting action to engage the base of the filler neck into the filler neck fitting on the top of the reservoir.
- Align and snap the filler neck retainer (1a) onto the stanchion on the outboard front corner of the battery tray. Be certain that the two latch features of the retainer are fully engaged with the stanchion.
- Fill the washer reservoir with any washer fluid drained from the filler neck during the removal procedure.