Removal And Installation: Removal
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The washer pump/motor can be removed from the washer reservoir without removing the reservoir from the vehicle.
- Turn the steering wheel to move the front wheels to the full left position.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the fasteners (1a) that secure the front of the left front wheel house splash shield to the front of the front fender wheel opening and the front bumper fascia.
- Pull the splash shield away from the front fascia far enough to access the washer pump/motor unit.
- Disconnect the washer pump/motor wire harness connector (1).NOTE:
Note the installed position of the washer hoses prior to disconnecting them from the washer pump.
- Disconnect the front and rear washer hose fittings (2) from the barbed outlet nipples of the washer pump and allow the washer fluid to drain into a clean container for reuse.
- Using hand pressure, firmly grasp and pull the washer pump (3) upward far enough to disengage the pump inlet nipple from the rubber grommet seal/filter screen in the reservoir. Care must be taken not to damage the reservoir.
- Remove the washer pump/motor unit from the washer reservoir.
- Remove the rubber grommet seal from the washer pump mounting hole in the reservoir and discard.