LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1350 (Wiper System & Washer System (Service Information)) >> Linkage, Wiper Arm >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0169528Courtesy of CHRYSLER GROUP, LLC
NOTE:

The front wiper linkage module includes the front wiper motor.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove both front wiper arms from the wiper pivots. Refer to FRONT WIPER ARM, REMOVAL  .
  3. Remove the cowl plenum cover/grille panel from over the front wiper linkage module. Refer to COVER, COWL PANEL, REMOVAL .
  4. Disconnect the wire harness connector (1) from the connector receptacle for the front wiper motor.
  5. Remove the three fasteners (2a) that secure the module (2b) bracket to the cowl plenum.
  6. Remove the front wiper linkage module from the cowl plenum as a unit.
scientia non olet · About LEMON Manuals