Front Washer Hoses And Tubes: Description
The front washer plumbing consists of small diameter rubber hoses that are routed along with the rear washer plumbing from the washer reservoir located at the left front corner of the engine compartment. Both reservoir hoses are attached to their respective front or rear outlet nipple of the washer pump/motor unit near the bottom of the reservoir. The front hose is then routed up into the engine compartment. The engine compartment hose is routed along the left side of the inner fender to the hood panel.
At the hood panel the front washer hose (1b) is routed through several retainers (1a) to a wye fitting on the inner hood panel reinforcement. The two front nozzle supply hoses are attached to the wye fitting and routed on the underside of the inner hood panel reinforcement to the two front washer nozzles (2).
Washer hose or tube is available for service only as roll stock, which must then be cut to length. The molded plastic washer hose fittings cannot be repaired. If these fittings are ineffective or damaged, they must be replaced.