LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1350 (Wiper System & Washer System (Service Information)) >> Check Valve, Washer >> Removal And Installation >> Rear Check Valve >> Removal

Rear Check Valve: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0168989Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Remove the spoiler from the outside of the upper liftgate header. Refer to SPOILER, REMOVAL .
  3. Pull the spoiler away from the upper liftgate header far enough to access and disconnect the washer supply hose from the barbed nipple (1) of the rear check valve (4).
  4. Disconnect the liftgate washer supply hose (3) from the other barbed nipple of the rear check valve and remove the check valve.
scientia non olet · About LEMON Manuals