LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1350 (Wiper System & Washer System (Service Information)) >> Check Valve, Washer >> Removal And Installation >> Rear Check Valve >> Installation

Rear Check Valve: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0168989Courtesy of CHRYSLER GROUP, LLC
  1. Connect the spoiler washer supply hose (3) to the barbed outlet nipple of the rear check valve (4). Be certain that the raised arrow (2) that indicates the flow direction on the center section of the valve is pointed toward the spoiler washer supply hose.
  2. Position the liftgate spoiler close enough to the upper liftgate header to access and connect the washer supply hose to the inlet barbed nipple (1) of the rear check valve.
  3. Install the spoiler to the outside of the upper liftgate header. Refer to SPOILER, INSTALLATION .
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals