Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read Drivetrain Control Module (DTCM) DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK THE BODY CONTROL MODULE (BCM) FOR DTCS
1. Ignition on.
2. With the scan tool, check for the presence of BCM related DTCs.
  Were any BCM related DTCs found?
  
  Yes
  - Diagnose the BCM DTCs in accordance with the Service Information.
  No
  - Perform the DTCM VERIFICATION TEST. Refer to DTCM VERIFICATION TEST .
  - Test complete.