LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1342 ((Forward Facing Camera Module (FFCM) - Electrical Diagnostics)) >> DTC Troubleshooting >> B1007-54-Half (Haptic Lane Feedback) - Missing Calibration >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

PERFORM THE FORWARD FACING CAMERA - CALIBRATION PROCEDURE 

  1. With the scan tool, perform the Forward Facing Camera - Calibration Procedure. Refer to MODULE, FORWARD FACING CAMERA (FFCM), MODULE PROGRAMMING .
  2. Perform the FORWARD FACING CAMERA VERIFICATION TEST. Refer to FORWARD FACING CAMERA VERIFICATION TEST  .

    Does this DTC reset after performing the Forward Facing Camera Verification Test?

    Yes 

    • Using the schematics as a guide, check the FFCM pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits and repair as necessary. Check for any technical bulletins that may apply. If no problems are found, replace the FFCM in accordance with the Service Information. Refer to MODULE, FORWARD FACING CAMERA (FFCM), REMOVAL AND INSTALLATION .
    • Perform the FORWARD FACING CAMERA VERIFICATION TEST. Refer to FORWARD FACING CAMERA VERIFICATION TEST  .

    No 

    • Test Complete.
scientia non olet · About LEMON Manuals