Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IF THE DTC IS ACTIVE
1. Turn the ignition on.
2. Using the scan tool, read Forward Facing Camera Module (FFCM) DTCs.
  Does the scan tool display this DTC as active?
  
  Yes
  - Using the schematics as a guide, check the FFCM pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits and repair as necessary. If no problems are found, replace the FFCM in accordance with the Service Information. Refer to MODULE, FORWARD FACING CAMERA (FFCM), REMOVAL AND INSTALLATION .
  - Perform the FORWARD FACING CAMERA VERIFICATION TEST. Refer to FORWARD FACING CAMERA VERIFICATION TEST .
  No
  - Go To 2
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this module. Wiggle the wiring and connectors while checking for shorted and open circuits.
3. Check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Check Service Bulletins for any possible causes that may apply.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the FORWARD FACING CAMERA VERIFICATION TEST. Refer to FORWARD FACING CAMERA VERIFICATION TEST .
  No
  - Test complete.