Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

VERIFY THE DTC IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Cycle the ignition from off to on.
4. With the scan tool, read the DTCs.
  Is the DTC active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the TESTING FOR AN INTERMITTENT CONDITION procedure. Refer to TESTING FOR AN INTERMITTENT CONDITION .
CHECK FOR DTCS IN THE ABS MODULE
1. With the scan tool, read DTCs in the ABS Module.
  Is the ABS Module reporting any DTCs?
  
  Yes
  - Perform the appropriate diagnostic procedure. Refer to DIAGNOSTIC CODE INDEX .
  No
  - Go To 3
CHECK RELATED HARNESS CONNECTIONS
1. Disconnect the EPS Module harness connectors.
2. Disconnect all related in-line harness connections (if equipped).
3. Disconnect the related component harness connectors.
4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
  - Proper connector installation.
  - Damaged connector locks.
  - Corrosion.
  - Other signs of water intrusion.
  - Weather seal damage (if equipped).
  - Bent terminals.
  - Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
  - Terminals that have been pushed back into the connector cavity.
  - Perform a terminal drag test on each connector terminal to verify proper terminal tension.
  Repair any conditions that are found.
5. Connect the EPS Module harness connectors. Be certain that the harness connectors are fully seated and the connector locks are fully engaged.
6. Connect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
7. Connect the related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
8. With the scan tool, erase DTCs.
9. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
10. With the scan tool, read EPS Module DTCs.
  Did the DTC return?
  
  Yes
  - Replace the Electric Power Steering (EPS) Module in accordance with Service Information. Refer to COLUMN, REMOVAL AND INSTALLATION .
  - Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .
  No
  - Perform the EPS VERIFICATION TEST. Refer to EPS VERIFICATION TEST .
  - Test complete.