LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1335 (2.4L Ignition System) >> Sensor, Camshaft Position >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position and install the camshaft position sensor into place, then install and tighten the nut to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  2. Connect the camshaft position sensor electrical connector.
  3. Position the heat shield, then install and tighten the nut to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  4. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
  6. When replacing the camshaft position sensor, connect the diagnostic scan tool, enter "Active Diagnosis" and run the self-learning procedure.
scientia non olet · About LEMON Manuals