LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1334 (1.3L Ignition System) >> Sensor, Camshaft Position >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the CMP sensor with a NEW  O-ring and connect the wiring harness connector.
  2. Install the heat shield and securely tighten the bolt.
  3. Install the catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable.
  5. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals