LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (1.3L Cooling System) >> Engine >> Pump, Water >> Removal And Installation >> Auxiliary Water Pump >> Installation

Auxiliary Water Pump: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. If removed, install the auxiliary water pump bracket and tighten the auxiliary water pump bracket bolts to the proper specification. Refer to TORQUE SPECIFICATIONS  .
  2. Connect and lock the auxiliary water pump wire harness connector.
  3. Install the auxiliary water pump in the bracket and securely tighten the collar bolt.
  4. Install the hoses and tighten the band clamps.
  5. Install and securely tighten the wiring duct bolt to the PTU mounting bracket.
  6. Connect and lock the PTU wire harness connector.
  7. Install the right front wheel splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
  8. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  9. Fill the cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 1.3L  .
  10. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals