LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1333 (1.3L Cooling System) >> Engine >> Bottle, Pressurized Coolant >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pressurized coolant bottle and engage the retaining clips.
  2. Connect the supply hose quick connector.
  3. Install the turbocharger supply hose to the pressurized coolant bottle and tighten the band clamp.
  4. Install the degassing hose to the pressurized coolant bottle and tighten the band clamp.
  5. Install the belly pan. Refer to BELLY PAN, INSTALLATION .
  6. Fill the cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 1.3L  .
  7. Remove the support and lower the vehicle.
  8. Run the engine until it reaches normal operating temperature. Check cooling system for leaks and correct fluid level. Refer to ADDING ADDITIONAL COOLANT  .
scientia non olet · About LEMON Manuals