LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (2.4L Cooling System) >> Engine >> Sensor, Coolant Temperature >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Do not open the radiator draincock with the system hot and under pressure. Serious burns from coolant can occur.

  1. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  2. Remove the battery. Refer to BATTERY, REMOVAL AND INSTALLATION .
  3. Drain the cooling system. Refer to DRAINING AND FILLING THE COOLING SYSTEM - 2.4L  .
  4. Disconnect the engine coolant temperature sensor wire harness connector (1).
    GC0165413Courtesy of CHRYSLER GROUP, LLC
  5. Remove the engine coolant temperature sensor (2).
scientia non olet · About LEMON Manuals