LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (2.4L Cooling System) >> Engine >> Heater, Engine Block >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0171629Courtesy of CHRYSLER GROUP, LLC
  1. Remove the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  2. Release the block heater power cord (1) from upper radiator inlet hose (2) and Powertrain Control Module (PCM) mounting bracket.
  3. Disconnect the power cord connector from the engine block heater (3).
    GC0128538Courtesy of CHRYSLER GROUP, LLC
  4. Lift the retainer clip (1) and slide the engine block heater (2) out of the engine block.
scientia non olet · About LEMON Manuals