Removal And Installation: Installation
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Position the accessory drive belt tensioner (1) in place and loosely install the accessory drive belt tensioner bolt (2).
- Install the accessory drive belt tensioner bolt (1). Tighten the accessory drive belt tensioner bolts to the proper specification.
Refer to TORQUE SPECIFICATIONS .
- Install the generator. Refer to GENERATOR, INSTALLATION .
- Remove the support and lower the vehicle.
- Start the engine and allow to run at idle momentarily. Shut the engine off and reinspect the belt alignment.