Diagnostic Test
WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR AN ACTIVE DTC
- With the scan tool, read ORC DTCs and record on the repair order.
- Record the Environmental Data.
- With the scan tool, erase DTCs.
- Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
- With the scan tool, read ORC DTCs.
Did the DTC return?
Yes
- Go To 2
No
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
- CHECK THE PASSENGER AIRBAG ENABLE (PAD) INDICATOR CIRCUIT FOR A SHORT TO GROUND
- Disconnect the PAD Indicator harness connector.
- Disconnect the ORC Module harness connectors.
- Check for continuity between ground and the PAD Enable circuit at the PAD harness connector.
Is there continuity between ground and the circuit?
Yes
- Repair the PAD Enable circuit for a short to ground.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
No
- Go To 3
- CHECK THE PASSENGER AIRBAG ENABLE (PAD) INDICATOR CIRCUITS FOR AN OPEN OR HIGH RESISTANCE
- Measure the resistance of the PAD Disable circuit from the PAD Enable harness connector to the ORC harness connector.
Is the resistance below 3.0 Ohms?
Yes
- Go To 4
No
- Repair the PAD Disable circuit an open or high resistance.
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
- Measure the resistance of the PAD Disable circuit from the PAD Enable harness connector to the ORC harness connector.
- REPLACE THE PAD INDICATOR
- Replace the PAD Indicator in accordance with the Service Information. Refer to SENSOR, OCCUPANT DETECTION, REMOVAL AND INSTALLATION .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST
.
Did the DTC return?
Yes
- Replace the Occupant Restraint Controller (ORC) in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROL (ORC), REMOVAL AND INSTALLATION .
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
No
- Test complete.