Diagnostic Test

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FOR AN ACTIVE DTC
1. With the scan tool, read ORC DTCs and record on the repair order.
2. Record the Environmental Data.
3. With the scan tool, erase DTCs.
4. Using the recorded Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
5. With the scan tool, read ORC DTCs.
  Did the DTC return?
  
  Yes
  - Go To 2
  No
  - Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Refer to RESTRAINTS SYSTEM INTERMITTENT TEST .
CHECK THE PASSENGER AIRBAG DISABLE (PAD) INDICATOR CIRCUIT FOR A SHORT TO VOLTAGE
WARNING:
Turn the ignition off, disconnect the battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.
1. Disconnect the PAD Indicator harness connector.
2. Disconnect the ORC Module harness connectors.
3. Turn the ignition on.
  NOTE:
  Probing of the circuit cavities at the Occupant Restraint Controller (ORC) body harness connectors or in- line connectors with an approved test leads from the test lead kit 10159-6 to prevent vehicle wiring harness connector damage during diagnostic procedures.
4. Measure the voltage between ground and the PAD Disable circuit at the indicator harness connector.
  Is there any voltage present?
  
  Yes
  - Repair the PAD circuit for a short to voltage.
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Go To 3
REPLACE THE PAD INDICATOR
1. Replace the PAD Indicator in accordance with the Service Information.
2. Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  Did the DTC return?
  
  Yes
  - Replace the Occupant Restraint Controller (ORC) in accordance with Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROL (ORC), REMOVAL AND INSTALLATION .
  - Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Refer to RESTRAINTS SYSTEM VERIFICATION TEST .
  No
  - Test complete.