LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2019 >> Renegade High Altitude, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1324 (Navigation/Telecommunication (Service Information)) >> Antenna, Long-Term Evolution 2 (LTE2) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the LTE2 antenna on to the studs on the instrument panel carrier, install the fasteners securing the LTE2 antenna to the instrument panel carrier and tighten securely.
  2. Connect the wire harness connector to the LTE2 antenna.
  3. Position the carrier bracket to the instrument panel carrier.
  4. Install the fasteners that retain the carrier reinforcement bracket and tighten them securely.
  5. Install the steering column. Refer to INSTALLATION, INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
scientia non olet · About LEMON Manuals